642 code(s) in this category. Page 8 of 27. Select one to see the detailed diagnosis.
Chasis (C)
The ABS warning lamp control circuit is shorted or open. The driver may see a permanently lit or non-functiona…
The powertrain control module reports a fault that the ABS module must consider (e.g. traction control engine …
The PWM control of the brake pressure modulation valves is faulty.…
The ABS control module has detected that the frequency of one wheel speed sensor signal does not match the oth…
Internal plausibility check of the combined ABS/TCS control module fails.…
The power steering control module has detected an implausible pressure or load signal from the steering pump. …
The pump motor ground return is open. The motor cannot run, and the system disables ABS and stability control.…
The brake booster vacuum sensor reports an implausible signal; brake assist functions are reduced. Boost contr…
The main ABS pump motor relay has problems.…
The brake control module has detected a fault in the active (electric or vacuum-controlled) brake booster. Act…
The ABS or brake control module has detected an electrical fault in the brake pump motor circuit. The pump is …
The brake control module has detected that the brake pump has run longer than the allowed maximum time. This t…
The brake control module has detected an implausible signal from the vacuum sensor on the brake booster. Moder…
The brake control module has detected an out-of-range or implausible signal from the brake booster pressure se…
The brake control module has detected an implausible signal from the booster vacuum sensor. Loss of vacuum sig…
The brake control module has detected an electrical fault in the booster boost (assist pressure) sensor circui…
The stability control module has detected that overall ESP performance is degraded — typically a plausibility …
The stability control module has detected that the yaw rate sensor signal is outside the plausible range durin…
The brake control module has detected an out-of-range signal from the brake pedal stroke sensor. Pedal travel …
Electrical fault in the brake pedal apply sensor circuit. The module cannot reliably detect whether the brake …
The stability control module has detected that the steering wheel position sensor reports a non-zero angle whe…
The ABS and electronic stability control module has a general fault.…
The air suspension control module has detected a fault in the compressor relay circuit. The compressor cannot …
The front left outlet solenoid valve does not respond hydraulically as expected.…