P025CFuel Pump Module A Control Circuit Low
Fuel pump module A control voltage below expected range. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
Can I keep driving? NO
STOP the vehicle in a safe place. Continuing to drive may cause serious engine damage or put your safety at risk.
Sistema Afectado
Aire / Combustible · Inyección, MAF, MAP, O₂
Relacionado con la mezcla aire-combustible: sensores de flujo, presión, inyectores o bomba.
Espacio para vendedores de repuestos
Aún no hay un anunciante en este espacio.
Symptoms You Will Notice
What you may observe when this code appears
- Check engine light on Hard start
- no start
- or stalling under load Power loss especially at high load or rpm Possible long cranking time
Possible Causes
The components or conditions that trigger this code
- 1Wiring shorted to ground Connector pins corroded - high contact resistance Harness chafing through insulation
How to Fix It — Step by Step
Recommended diagnostic and repair procedure
- 1Difficulty: medium. Estimated time: 0.5-4 hours. Estimated cost: €100-€
- 2DIY possible
Note: This information is for general reference. For precise diagnostics and safety repairs, always consult a certified mechanic.
Estimated Cost
Approximate range in USD (varies by region and shop)
Sensors + injectors
* Diagnosis only: $50–$150
Quick Info
Dig Deeper
Videos, images and service manuals
Have Another Code?
Look it up directly: