P34B6B Camshaft Position Actuator Temperature Sensor Circuit Low Bank 1
Cam actuator B temperature sensor on bank 1 signal voltage below expected range. The camshaft position sensor identifies which cylinder is on the compression stroke — without it the ECM cannot run sequential injection or coil-on-plug ignition correctly.
Can I keep driving? With caution
You can drive to the shop, but do not postpone the repair. The problem may worsen and damage other components.
Sistema Afectado
Motor · Powertrain
La falla pertenece al grupo motopropulsor (motor y gestión electrónica).
Espacio para vendedores de repuestos
Aún no hay un anunciante en este espacio.
Symptoms You Will Notice
What you may observe when this code appears
- Check engine light on Power loss especially in mid-rpm range Possible rough idle or stalling Increased fuel consumption
Possible Causes
The components or conditions that trigger this code
- 1Signal wire shorted to ground Connector pins corroded - high contact resistance Harness chafing through insulation
How to Fix It — Step by Step
Recommended diagnostic and repair procedure
- 1Difficulty: medium. Estimated time: 0.5-3 hours. Estimated cost: €80-€
- 2DIY possible
Note: This information is for general reference. For precise diagnostics and safety repairs, always consult a certified mechanic.
Estimated Cost
Approximate range in USD (varies by region and shop)
Varies by diagnosis
* Diagnosis only: $50–$150
Quick Info
Dig Deeper
Videos, images and service manuals
Have Another Code?
Look it up directly: